The Seventh Week

17th May 2010,

- repairing whack actuator.

* rewire whack actuator that not connected correctly.

- install tube for WAP machine.

* the tubes need to connect the nest at WAP with device net.

* device net control the air flow to operate the nest.

* nest function is to hold the hardisk so it can be whack efficiently.

- wiring other WAP machine.

18th May 2010,

- tidy up wire for WAP machine.

- assemble blower for WAP.

* blower function is to supply air to clean the disk.

- drill the cover for WAP.

* the cover does not has hole to put in the skru so it should be drilled.

- assemble datum for ARIRI machine.

* datum for different machine has different function.

* datum for ARIRI used to hold the disk as it will be lighted and the machine will scanned the ramp to measured the ramp space.

19th May 2010,

- continue assemble datum for ARIRI and install it to the machine.\

- prepare din rail,

* din rail is a rail that skru on the machine to place the terminal block, relay and input output terminal.

- wiring WAP blower.

* a long wire needed to connect the blower to the power supply.

20th May 2010,

- continue wiring WAP blower.

- wiring whack actuator for the componet that just arrived.

- tidy up wire for WAP machine.

21th May 2010,

- wiring another WAP machine.

* component that just install on WAP some of it need to wire to input output terminal.

- install cover for WAP machine.

- tidy up wire for WAP machine.