The Tenth Week

7th June 2010,

- help Mr. Jon setup Ariri.

- wiring WAP blower to AC power supply.

* print label and put in the wires correctly.

* strip the wire and clamp it with Y-terminal.

- wiring relay with terminal block.

- label the wire correctly.

8th June 2010,

- wiring relay for another WAP machine.

* print and labeling th wire.

- put the conveyor on WAP.

- put the back cover WAP.

* use the rhombus and M8 screw to place the cover.

- put fitting to the vacuum tube.

* all the vacuum tube from cylinder and part lift are assemble to one end.

9th June 2010,

- help Mr. Jom setup ARIRI.

* tidy up ARIRI wires.

* take out part lift to check tie wiring if anything wrong.

* change the wire at address D25I:0.6 to D25I:0.7.

* check any lose wire that is not clamp properly.

10th June 2010,

- solder diods to solenoids.

* six diods are soldered together and then soldered to the wire from solenoids

* shrink cable must be put before it is soldered to solenoid.

* used the blower to shrink the cable.

- put stand for laser controller.

* the stand is actually for APCBA machine.

* the stand is installed because the cable can not be fit in due to space that is limited.

11th June 2010,

- put stand for laser controller for another ARIRI machine.

- put blower on WAP machine.

- assemble tube on the blower.

- put cable for light box ARIRI's.